Product Overview
Specify finished diameter, fit, straightness and surface roughness for precision shaft and locating applications.
Applications and Selection
630, also designated 17-4PH, is a precipitation-hardening stainless steel. Different aging conditions change its mechanical properties, so a material specification should include the required condition where applicable.
State whether the diameter and straightness apply before or after final aging. Include the strength or hardness requirement and any finish zones on the drawing.
Specifications
Material identification
| Item | Technical Parameters |
|---|---|
| Material Grade | 17-4PH |
| Chinese National Standard Grade | 05Cr17Ni4Cu4Nb |
| UNS Grade | S17400 |
| DIN Grade | 1.4542 |
Chemical composition (wt%)
| C | Si | Mn | P | S | Cr | Ni | Cu | Nb |
|---|---|---|---|---|---|---|---|---|
| ≤0.07 | ≤1.00 | ≤1.00 | ≤0.040 | ≤0.030 | 15.00–17.50 | 3.00–5.00 | 3.00–5.00 | 0.15–0.45 |
Mechanical properties
| Condition | Tensile Strength ≥ MPa | Yield Strength ≥ MPa | Elongation ≥ | Hardness HRC |
|---|---|---|---|---|
| A (Solution Annealed) | 1255 | 1105 | 3% | ≤38 |
| H900 | 1310 | 1180 | 10% | 40–45 |
| H1025 | 1060 | 1000 | 12% | 35–39 |
| H1075 | 1000 | 865 | 13% | 33–37 |
| H1150 | 930 | 725 | 16% | 28–32 |
Dimensions and precision
| Item | Technical Requirements |
|---|---|
| Common Diameter Range | Ø3.0 mm–Ø300 mm |
| Diameter Tolerance | Standard: h8, h9; High Precision: h7, f7, g6, h6 |
| Roundness | ≤1/2 diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | Ø40 mm and below: 3 meters; Over Ø40 mm: up to 6 meters (custom fixed lengths available) |
| End Face Requirements | Flat ends, chamfered and deburred |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot-rolled base material → Precision drawing → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 2 | Hot-rolled base material → Peeling & straightening → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 3 | Hot-rolled base material → Peeling & straightening → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
