Product Overview
Specify finished diameter, fit, straightness and surface roughness for precision shaft and locating applications.
Applications and Selection
431 is a hardenable stainless grade. When the bar is used in a loaded shaft, the drawing should identify both the required material condition and the size of the ground running or bearing surface.
Specify the ground diameter, straightness and the relevant mechanical property or hardness acceptance criteria. Indicate which values are needed on the inspection record.
Specifications
Material identification
| Item | Technical Parameter |
|---|---|
| Material Grade | 431 |
| Chinese National Standard Grade | 17Cr16Ni2 (1Cr17Ni2) |
| UNS Grade | S43100 |
| DIN Grade | 1.4057 |
Chemical composition (wt%)
| C | Si | Mn | P | S | Cr | Ni |
|---|---|---|---|---|---|---|
| ≤0.20 | ≤1.00 | ≤1.00 | ≤0.040 | ≤0.030 | 15.00–17.00 | 1.50–2.50 |
Mechanical properties
| Item | Mechanical Property |
|---|---|
| Tensile Strength Rm | ≥860 MPa |
| 0.2% Proof Strength Rp0.2 | ≥655 MPa |
| Elongation after Fracture A | ≥15% |
| Brinell Hardness | 260–300 HB |
Dimensions and precision
| Item | Technical Requirements |
|---|---|
| Common Diameter Range | Ø3.0 mm – Ø300 mm |
| Diameter Tolerance | Standard: h8, h9; High Precision: h7, f7, g6, h6 |
| Roundness | ≤1/2 of diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | Ø40 mm and below: 3 meters; Over Ø40 mm: 6 meters available (custom fixed lengths supported) |
| End Face Requirements | Flat ends, chamfered and deburred |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot-rolled base material → Precision drawing → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 2 | Hot-rolled base material → Peeling and straightening → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 3 | Hot-rolled base material → Peeling and straightening → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
| Process 4 | Hot-rolled base material → Quenching and tempering → Peeling and straightening → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
| Process 5 | Hot-rolled base material → Peeling and straightening → Surface quenching → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
