Product Overview
Specify finished diameter, fit, straightness and surface roughness for precision shaft and locating applications.
Applications and Selection
2507 is a super duplex grade often considered where the design calls for a high level of corrosion resistance. Suitability still depends on the fluid, temperature and fabrication conditions.
Provide the complete material requirement, reporting needs and ground fit. Indicate which bar surfaces must remain at the as-supplied finish after machining.
Specifications
Material identification
| Item | Technical Parameter |
|---|---|
| Material Grade | 2507 |
| Chinese National Standard Grade | 022Cr25Ni7Mo4N |
| UNS Grade | S32750 |
| DIN Grade | 1.4410 |
Chemical composition (wt%)
| C | Si | Mn | P | S | Cr | Ni | Mo | N |
|---|---|---|---|---|---|---|---|---|
| ≤0.030 | ≤1.00 | ≤1.20 | ≤0.035 | ≤0.020 | 24.00–26.00 | 6.00–8.00 | 3.00–5.00 | 0.24–0.32 |
Mechanical properties
| Item | Mechanical Property |
|---|---|
| Tensile Strength Rm | ≥800 MPa |
| Yield Strength Rp0.2 | ≥550 MPa |
| Elongation after Fracture A | ≥15% |
| Brinell Hardness | ≤310 HB |
Dimensions and precision
| Item | Technical Requirements |
|---|---|
| Common Diameter Range | Ø3.0 mm – Ø300 mm |
| Diameter Tolerance | Conventional: h8, h9; High Precision: h7, f7, g6, h6 |
| Roundness | ≤1/2 of diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | Ø40 mm and below: 3 meters; Above Ø40 mm: 6 meters available (custom fixed lengths supported) |
| End Face Requirements | Flat ends, chamfered and deburred |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot rolled base material → Precision drawing → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 2 | Hot rolled base material → Peeling and straightening → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 3 | Hot rolled base material → Peeling and straightening → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
