Product Overview
Specify finished diameter, fit, straightness and surface roughness for precision shaft and locating applications.
Applications and Selection
30Cr13 is specified here as a distinct material designation. For replacement parts, match the designation and specified condition on the drawing before comparing dimensions with another ground bar.
Highlight areas that undergo further heat treatment or machining. Give the incoming diameter and tolerance as well as any hardness requirement on the final part.
Specifications
Material identification
| Item | Technical Parameters |
|---|---|
| Material Grade | 30Cr13 |
| Former Grade | 3Cr13 |
| Equivalent Grades | SUS420J2, 1.4028, S42080 |
Chemical composition (wt%)
| C | Si | Mn | P | S | Cr | Ni |
|---|---|---|---|---|---|---|
| 0.26–0.35 | ≤1.00 | ≤1.00 | ≤0.040 | ≤0.030 | 12.00–14.00 | ≤0.60 |
Mechanical properties
| Item | Mechanical Properties |
|---|---|
| Tensile Strength Rm | ≥735 MPa |
| Yield Strength Rp0.2 | ≥540 MPa |
| Elongation after Fracture A | ≥12% |
| Brinell Hardness | 217–241 HB |
Dimensions and precision
| Item | Technical Requirements |
|---|---|
| Common Diameter Range | Ø3.0 mm – Ø300 mm |
| Diameter Tolerance | Standard grade: h8, h9; High precision grade: h7, f7, g6, h6 |
| Roundness | ≤1/2 diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | Ø40 mm and below: 3 meters; Above Ø40 mm: 6 meters available (custom fixed lengths supported) |
| End Face Requirements | Flat ends, chamfered and deburred |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot rolled base material → Precision drawing → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 2 | Hot rolled base material → Peeling & straightening → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 3 | Hot rolled base material → Peeling & straightening → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
| Process 4 | Hot rolled base material → Quenching and tempering → Peeling & straightening → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
| Process 5 | Hot rolled base material → Peeling & straightening → Surface quenching → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
