Product Overview
Specify finished diameter, fit, straightness and surface roughness for precision shaft and locating applications.
Applications and Selection
420 is martensitic stainless steel. Its properties depend on heat treatment, so the grade number alone does not establish the finished hardness of an ordered shaft or pin.
Specify whether you need stock for further machining or a final ground size. Separately list the required condition, hardness range and any grinding allowance.
Specifications
Material identification
| Item | Technical Parameters |
|---|---|
| Material Grade | 420 |
| Chinese National Standard Grade | 2Cr13 |
| UNS Grade | S42000 |
| DIN Grade | 1.4028 |
Chemical composition (wt%)
| C | Si | Mn | P | S | Cr |
|---|---|---|---|---|---|
| 0.16–0.25 | ≤1.00 | ≤1.00 | ≤0.040 | ≤0.030 | 12.00–14.00 |
Mechanical properties
| Item | Mechanical Properties |
|---|---|
| Tensile Strength Rm | ≥640 MPa |
| 0.2% Proof Strength Rp0.2 | ≥440 MPa |
| Elongation after Fracture A | ≥20% |
| Brinell Hardness | ≤241 HB |
Dimensions and precision
| Item | Technical Requirements |
|---|---|
| Common Diameter Range | Ø3.0 mm – Ø300 mm |
| Diameter Tolerance | Standard: h8, h9; High Precision: h7, f7, g6, h6 |
| Roundness | ≤1/2 of diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | Ø40 mm and below: 3 meters; Above Ø40 mm: 6 meters available (custom fixed lengths supported) |
| End Face Requirements | Flat ends, chamfered and deburred |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot Rolled Base Material → Precision Drawing → Centerless Precision Grinding | Ra 0.4–0.8 µm |
| Process 2 | Hot Rolled Base Material → Peeling & Straightening → Centerless Precision Grinding | Ra 0.4–0.8 µm |
| Process 3 | Hot Rolled Base Material → Peeling & Straightening → Centerless Precision Grinding → Polishing | Ra ≤0.2 µm |
| Process 4 | Hot Rolled Base Material → Quenching and Tempering → Peeling & Straightening → Centerless Precision Grinding → Polishing | Ra ≤0.2 µm |
| Process 5 | Hot Rolled Base Material → Peeling & Straightening → Surface Hardening → Centerless Precision Grinding → Polishing | Ra ≤0.2 µm |
