Product Overview
Specify finished diameter, fit, straightness and surface roughness for precision shaft and locating applications.
Compare grade-specific selection questions in our 303, 304 and 316L precision ground bar guide.
Applications and Selection
316L is a low-carbon stainless grade. Use the grade designation from the drawing if material traceability matters, especially when the shaft is part of an assembly with defined cleaning or material requirements.
Indicate which surfaces remain ground and which will be cut or welded. Include the stock diameter, straightness and any final surface condition required after fabrication.
Specifications
Material identification
| Item | Technical Parameter |
|---|---|
| Material Grade | 316L |
| Chinese National Standard Grade | 022Cr17Ni12Mo2 |
| UNS Grade | S31603 |
| DIN Grade | 1.4404 |
Chemical composition (wt%)
| C | Si | Mn | P | S | Cr | Ni | Mo |
|---|---|---|---|---|---|---|---|
| ≤0.030 | ≤1.00 | ≤2.00 | ≤0.045 | ≤0.030 | 16.00–18.50 | 10.00–14.00 | 2.00–3.00 |
Mechanical properties
| Item | Mechanical Property |
|---|---|
| Tensile Strength Rm | ≥480 MPa |
| Yield Strength Rp0.2 | ≥170 MPa |
| Elongation after Fracture A | ≥40% |
| Brinell Hardness | ≤187 HB |
Dimensions and precision
| Item | Technical Requirements |
|---|---|
| Common Diameter Range | Ø3.0 mm – Ø300 mm |
| Diameter Tolerance | Standard grade: h8, h9; High precision grade: h7, f7, g6, h6 |
| Roundness | ≤1/2 of diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | 3 meters for Ø40 mm and below; 6 meters for diameter above Ø40 mm (custom fixed lengths available) |
| End Face Requirements | Flat ends with chamfering and deburring |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot-rolled base material → Precision drawing → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 2 | Hot-rolled base material → Peeling and straightening → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 3 | Hot-rolled base material → Peeling and straightening → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
