Product Overview
Specify finished diameter, fit, straightness and surface roughness for precision shaft and locating applications.
Compare grade-specific selection questions in our 303, 304 and 316L precision ground bar guide.
Applications and Selection
304 is a general-purpose austenitic stainless grade. Precision ground round stock is useful for guide shafts and pins whose outside diameter is used directly or needs only limited machining.
Confirm whether the drawing refers to a ground bar or a coated shaft. Specify the diameter tolerance, desired finish and inspection method if the bar runs directly in a bushing.
Specifications
Material identification
| Property | Catalog value |
|---|---|
| Material grade | 304 |
| GB grade | 06Cr19Ni10 |
| UNS grade | S30400 |
| DIN grade | 1.4301 (X5CrNi18-10) |
Chemical composition (wt%)
| C | Si | Mn | P | S | Cr | Ni |
|---|---|---|---|---|---|---|
| ≤0.08 | ≤1.00 | ≤2.00 | ≤0.045 | ≤0.030 | 18.00–20.00 | 8.00–10.50 |
Mechanical properties
| Property | Mechanical properties |
|---|---|
| Tensile strength Rm | ≥520 MPa |
| 0.2% proof strength Rp0.2 | ≥205 MPa |
| Elongation after fracture A | ≥35% |
| Brinell hardness | ≤187 HB |
Dimensions and precision
| Property | Dimensional requirements |
|---|---|
| Listed diameter range | Ø3.0 mm – Ø300 mm |
| Diameter tolerance | Standard h8 or h9. Precision h7, f7, g6 or h6. |
| Roundness | ≤ half the diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Listed standard length | Up to Ø40 mm: 3 m. Above Ø40 mm: 6 m. Custom lengths on request. |
| End finish | Flat ends, chamfered and deburred |
Processing and surface finish
| Process route | Process sequence | Surface roughness |
|---|---|---|
| Route 1 | Hot rolled stock → precision drawing → centerless grinding | Ra 0.4–0.8 µm |
| Route 2 | Hot rolled stock → peeling and straightening → centerless grinding | Ra 0.4–0.8 µm |
| Route 3 | Hot rolled stock → peeling and straightening → centerless grinding → polishing | Ra ≤0.2 µm |
