Product Overview
Specify finished diameter, fit, straightness and surface roughness for precision shaft and locating applications.
Applications and Selection
Where a drawing specifies 303Cu, record that grade explicitly on the purchase request. The copper-bearing grade has a different material designation from standard 303, although the ground bars may look alike.
Identify the areas that must remain at the supplied diameter and the features to be cut on a lathe. Provide the bar length, diameter tolerance and material documentation requirement.
Specifications
Material identification
| Item | Technical Parameters |
|---|---|
| Material Grade | 303Cu |
| Chinese National Standard Grade | Y1Cr18Ni9Cu |
| UNS Grade | – |
| DIN Grade | – |
Chemical composition (wt%)
| C | Si | Mn | P | S | Cr | Ni | Cu |
|---|---|---|---|---|---|---|---|
| ≤0.15 | ≤1.00 | ≤3.00 | ≤0.20 | 0.15~0.35 | 17.00~19.00 | 8.00~10.00 | 1.50~3.50 |
Mechanical properties
| Item | Mechanical Properties |
|---|---|
| Tensile Strength Rm | ≥500 MPa |
| 0.2% Proof Strength Rp0.2 | ≥190 MPa |
| Elongation after Fracture A | ≥35% |
| Brinell Hardness | ≤187 HB |
Dimensions and precision
| Item | Technical Requirements |
|---|---|
| Common Diameter Range | Ø3.0 mm – Ø300 mm |
| Diameter Tolerance | Standard: h8, h9; High Precision: h7, f7, g6, h6 |
| Roundness | ≤1/2 diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | Ø40 mm and below: 3 meters; Over Ø40 mm: 6 meters available (custom fixed lengths supported) |
| End Face Requirements | Flat ends, chamfered and deburred |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot-rolled base material → Precision drawing → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 2 | Hot-rolled base material → Peeling & straightening → Centerless precision grinding | Ra 0.4–0.8 µm |
| Process 3 | Hot-rolled base material → Peeling & straightening → Centerless precision grinding → Polishing | Ra ≤0.2 µm |
