Product Overview
Select coating thickness, finished outside diameter and tolerances to match the application drawing.
Applications and Selection
2205 duplex stainless is the shaft substrate. Where the design relies on hard chrome in a sliding region, verify the coating requirement for that region and the conditions where bare substrate remains exposed.
Provide the service fluid, finished fit and coating boundaries. If the design needs evidence of material grade or coating inspection, call that out with the drawing.
Specifications
Finish and dimensional requirements
| Item | Technical Parameters |
|---|---|
| Base Material Grade | 2205 Duplex Stainless Steel |
| GB Standard Grade | 022Cr22Ni5Mo3N |
| UNS Grade | S32205 |
| DIN Grade | 1.4462 |
| Surface Treatment | Chrome Plated |
| Hard chrome thickness | Diameter ≤Ø20: 15 µm; Diameter>Ø20: 20 µm, customizable thickness as required |
| Surface Hardness after Chrome Plated | HV800–1100 |
| Common Diameter Range | Ø3.0 mm–Ø300 mm |
| Diameter Tolerance | Conventional grades: h8, h9; High-precision grades: h7, f7, g6, h6 |
| Roundness | ≤1/2 of diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | Fixed length of 3 meters for Ø40 mm and below; fixed length of 6 meters for diameters above Ø40 mm, customized fixed lengths available for large specifications |
| End Face Requirements | Flat ends with chamfering and burr removal |
Base material composition (wt%)
| C | Si | Mn | P | S | Cr | Ni | Mo | N |
|---|---|---|---|---|---|---|---|---|
| ≤0.030 | ≤1.00 | ≤2.00 | ≤0.030 | ≤0.020 | 21.00–23.00 | 4.50–6.50 | 2.50–3.50 | 0.14–0.20 |
Base material mechanical properties
| Item | Mechanical Properties |
|---|---|
| Tensile Strength Rm | ≥620 MPa |
| 0.2% Proof Strength Rp0.2 | ≥450 MPa |
| Elongation after Fracture A | ≥25% |
| Base Material Hardness | ≤293 HB |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot-rolled base material → Precision drawing → Centerless precision grinding → Polishing → Chrome Plated → Secondary polishing | Ra ≤0.2 µm |
| Process 2 | Hot-rolled base material → Peeling & straightening → Centerless precision grinding → Polishing → Chrome Plated → Secondary polishing | Ra ≤0.2 µm |
| Process 3 | Forged round bar → Turning finishing → Centerless precision grinding → Polishing → Chrome Plated → Secondary polishing | Ra ≤0.2 µm |
