Product Overview
Select coating thickness, finished outside diameter and tolerances to match the application drawing.
Applications and Selection
The 304 substrate and hard chrome exterior serve separate roles. For a linear shaft or cylinder rod, identify the portion contacted by the seal or bearing and whether the listed diameter is measured after coating.
Mark the usable plated length and any excluded areas such as threads. Provide the diameter fit, finish and coating thickness needed on the running surface.
Specifications
Finish and dimensional requirements
| Item | Performance Parameters |
|---|---|
| Base Material Grade | 304 |
| GB Standard Grade | 06Cr19Ni10 |
| Surface Treatment | Chrome Plated |
| Hard chrome thickness | ≤Ø20: 15 µm; >Ø20: 20 µm, thickness customizable upon request |
| Surface Hardness after Chrome Plated | HV800–1100 |
| Common Diameter Range | Ø3.0 mm–Ø300 mm |
| Diameter Tolerance | Standard: h8, h9; High Precision: h7, f7, g6, h6 |
| Roundness | ≤1/2 of diameter tolerance |
| Straightness | ≤0.10 mm/1000 mm |
| Standard Length | 3m fixed length for Ø40 mm and below; 6m fixed length for sizes above Ø40 mm, custom lengths available for large sizes |
| End Face Requirement | Flat ends with chamfering and deburring |
Base material composition (wt%)
| C | Si | Mn | P | S | Cr | Ni |
|---|---|---|---|---|---|---|
| ≤0.08 | ≤1.00 | ≤2.00 | ≤0.045 | ≤0.030 | 18.00–20.00 | 8.00–11.00 |
Base material mechanical properties
| Item | Specification |
|---|---|
| Tensile Strength Rm | ≥520 MPa |
| Yield Strength Rp0.2 | ≥205 MPa |
| Elongation after Fracture A | ≥40% |
| Base Material Hardness | ≤187 HB |
Processing and surface finish
| Process Type | Complete Process Flow | Surface Roughness |
|---|---|---|
| Process 1 | Hot-rolled Base Material → Precision Drawing → Centerless Precision Grinding → Polishing → Chrome Plated → Finishing Polishing | Ra ≤0.2 µm |
| Process 2 | Hot-rolled Base Material → Peeling & Straightening → Centerless Precision Grinding → Polishing → Chrome Plated → Finishing Polishing | Ra ≤0.2 µm |
| Process 3 | Forged Round Bar → Turning → Centerless Precision Grinding → Polishing → Chrome Plated → Finishing Polishing |
